Products · Fired Equipment & Process Heaters
To establish the project design basis for “Indirect Water Bath Heaters”, confirm “Process service and bath conditions” and its inputs: Define heated-fluid flow and properties, pressure/temperature, target temperature, bath-water conditions, heat source and site limits. Final values, supply limits and acceptance criteria are recorded in approved engineering documents; no generic capacity or catalogue guarantee is assumed.
From project definition to delivery
Engineering of Indirect Water Bath Heaters concentrates on required heat duty, bath temperature, fire-tube heat flux, process-coil pressure drop, burner turndown, freeze protection, expansion and low-level safeguarding. The selected configuration is verified against normal, minimum, start-up, shutdown and credible upset cases, then checked for operability, maintainability, energy use, process safety and site interfaces before the design is frozen.
The design basis for Indirect Water Bath Heaters is defined from service data, design conditions, and battery limits. For this equipment, Process service and bath conditions and Fuel and process conditions must be completed in the datasheet and design documents; performance values and guarantees are set only after the project basis is approved.
Materials, corrosion allowance, sour-service requirements, piping classes, nozzle design, insulation, coating, supports and maintenance access are coordinated with the actual process conditions and project code hierarchy.
Control philosophy, alarms and trips, cause-and-effect logic, interlocks, start-up and shutdown sequences, safe depressurization and operator access are developed consistently from the P&IDs through functional testing.
Battery limits, tie-in points, structural loads, cabling, instrumentation, drains, vents, access routes, lifting envelopes and shipping constraints are controlled through coordinated models and interface drawings.
From project definition to delivery
Proposal quality depends on complete input data and an explicit acceptance basis. The following lists provide a practical starting point and are completed during technical clarification.
Technical Datasheet
The heat-release and turndown values are published for one indirect-fired heater family. Bath medium, coil, fuel and burner configuration remain application-specific.
| Parameter | Published value | Reference basis | Applicability / limit |
|---|---|---|---|
| Published performance range | 0.1–15 MMBtu/h | Published performance range for one indirect-fired heater product family. | Different sizes/configurations span the range; do not treat it as one model capacity. |
| Natural-draft burner turndown | 3:1 | Published turndown for natural-draft burner arrangements; forced-draft options may differ. | Minimum stable firing and emissions must be established for the selected burner/fuel and operating case. |
| Intermediate bath media | Water, eutectic salt or thermal oil | Published design options for the indirect-heater family. | Media are alternatives, not interchangeable defaults; corrosion, freeze/boil limits and temperature control differ. |
Delham Engineering
Send the available process data, battery limits and expected document list for a technical proposal. The engineering team will identify missing information through a structured clarification register.
